STEERING COLUMN ASSEMBLY REASSEMBLY


  1. INSTALL STEERING MAIN SHAFT ASSEMBLY


    1. A01E05WE01

      Using a snap ring expander, install a new steering main shaft snap ring (inner side) to the steering main shaft.

    2. Install the steering main shaft to the steering column tube.

    3. A01DV5SE01

      Using a snap ring expander, install a steering main shaft snap ring.

  2. INSTALL STEERING MAIN SHAFT BEARING


    1. A01DX1HE01

      Using SST and a hammer, tap in the bearing until it is flush with the edge of the steering column tube.

      SST
      09608-06041

  3. INSTALL KEY INTER LOCK SOLENOID (for Automatic Transmission)


    1. A01DYICE01

      Install the solenoid to the steering column bracket upper with the 2 screws.

  4. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY


    1. A01DW8EE01

      Install the switch to the steering column bracket upper with the 2 claws.

  5. INSTALL UNLOCK WARNING SWITCH ASSEMBLY


    1. A01DWOEE01

      Install the switch to the steering column bracket upper with the 2 claws.

  6. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY


    1. Make sure that the lock cylinder is on ACC.

    2. Install the ignition switch lock cylinder.

  7. INSTALL STEERING LOCK OPERATION


    1. Check that the steering lock mechanism activated when the key is removed.

    2. Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.

      If there is any abnormality, replace the ignition switch lock cylinder assembly.

  8. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY


    1. A01E01EE01

      Install the steering column upper bracket and steering column upper clamp with 2 new tapered-head bolts.

    2. Tighten the 2 tapered-head bolts until the bolt heads break off.

  9. INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)


    1. Connect the transponder key amplifier connector.

    2. A01E2WXE03

      Align the claw of the transponder key amplifier with the upper bracket.

    3. Push in the transponder key amplifier and install it to the upper bracket.

      Note

      Do not push in the amplifier with excessive force as it may be damaged.

  10. INSTALL KEY CYLINDER LIGHT ASSEMBLY (w/ Key Cylinder Light)


    1. A01E1AF

      Connect the connector.

    2. Push in the key cylinder light assembly in the direction indicated by the arrow in the illustration to install it.

  11. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY


    1. A01E23LE05

      Align the matchmarks on the steering intermediate shaft and steering gear.

    2. Install the steering intermediate shaft to the steering gear with the bolt.

      Torque:
      35 N*m  { 357 kgf*cm, 26 ft.*lbf }

  12. INSTALL STEERING SLIDING WITH COUPLING YOKE SUB-ASSEMBLY


    1. A01DW5YE04

      Align the matchmarks on the yoke and steering main shaft.

    2. Install the steering yoke with the bolt.

      Torque:
      28 N*m  { 286 kgf*cm, 21 ft.*lbf }