NOISE FILTER INSTALLATION
PROCEDURE
INSTALL RADIO SETTING CONDENSER
-
Attach the claw to install a new terminal cover to the wire harness.
Note:Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.
Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.
Do not use excessive force when inserting the wire harness into the terminal cover.
If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.
-
Attach the 3 claws to install the new terminal cover with wire harness to a new condenser.
Note:Do not use excessive force when inserting the terminal cover into the condenser.
If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.
Attach the clamp to temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
4.5 N*m
46 kgf*cm
40 in.*lbf
-
INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
INSTALL REAR DOOR SCUFF PLATE LH
INSTALL REAR SEAT ASSEMBLY
for LH:
for RH:
INSTALL REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE
w/o Spare Tire, for Compact Spare Tire:
w/ Full Size Spare Tire:
INSTALL REAR DECK TRIM COVER (w/ Full Size Spare Tire)
INSTALL REAR FLOOR FINISH PLATE (w/o Spare Tire, for Compact Tire)
INSTALL DECK FLOOR BOX LH
INSTALL DECK BOARD ASSEMBLY (w/ Full Size Spare Tire)
INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire, for Compact Tire)
INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
INSTALL PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/ Partition Net)