AIRBAG SYSTEM DATA LIST / ACTIVE TEST

  1. READ DATA LIST

    Tip:

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the intelligent tester on.

    6. Enter the following menus: Body / SRS Airbag / Data List.

    7. According to the display on the intelligent tester, read the Data List.

      Table 1. SRS Airbag

      Tester Display

      Measurement Item/Range

      Normal Condition

      Diagnostic Note

      Display Type Information

      Display Type Information/

      LR: The display is indicated by LH/RH

      DP: The display is indicated by Driver/Passenger

      LR

      -

      Number of Past DTC

      Number of Past DTCs/

      Min.: 0, Max.: 255

      0

      -