BACK DOOR LOCK INSTALLATION

PROCEDURE


  1. INSTALL BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)

    Note


    • When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.

    • When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.


    1. Apply MP grease to the sliding parts of the back door lock assembly.

    2. B005B0IE02

      Temporarily install the 4 bolts in the order shown in the illustration.

    3. Tighten the 4 bolts.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

    4. Attach the clamp.

    5. Connect the connector.

  2. INSTALL BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)

    Note


    • When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.

    • When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.


    1. Apply MP grease to the sliding parts of the back door lock assembly.

    2. Install the back door lock assembly with the 3 bolts.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

    3. Connect the connector.

  3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

    Click here

  4. INSTALL BACK DOOR LOCK COVER (w/ Power Back Door)

    Click here

  5. INSTALL BACK DOOR LOCK COVER (w/o Power Back Door)

    Click here

  6. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)

    Click here

  7. INSTALL PULL HANDLE (w/ Power Back Door)

    Click here

  8. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)

    Click here

  9. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)

    Tech Tips

    Use the same procedure as for the LH side.

  10. INSTALL BACK DOOR SIDE GARNISH LH

    Click here

  11. INSTALL BACK DOOR SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  12. INSTALL BACK DOOR CENTER GARNISH

    Click here

  13. INSPECT POWER BACK DOOR SYSTEM (w/ Power Back Door)

    Click here

  14. INSPECT BACK DOOR CLOSER SYSTEM (w/ Power Back Door)

    Click here