CHARGING SYSTEM PRECAUTION

  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

    System Name

    See Procedure

    Stop and Start System

    Click hereClick here

    Power Door Lock Control System

  2. IGNITION SWITCH EXPRESSIONS

    1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression

      Ignition Switch (Position)

      Engine Switch (Condition)

      Ignition Switch off

      LOCK

      Off (Lock)

      Ignition Switch ACC

      ACC

      On (ACC)

      Ignition Switch ON

      ON

      On (IG)

      Engine Start

      START

      On (Start)
Note:

  • Check that the battery cables are connected to the correct terminals.

  • Disconnect the battery cables when the battery is given a quick charge.

  • Do not perform tests with a high voltage insulation resistance tester.

  • Never disconnect the battery cables while the engine is running.

  • Check that the charging cable nuts are tightened on terminal B of the generator assembly and on the No. 1 engine room relay block.