COMBINATION METER REMOVAL

CAUTION / NOTICE / HINT

Note

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

    Click here

  2. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  3. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  6. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD

    Click here

  7. REMOVE INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY

    Click here

  8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

  9. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

    Click here

  10. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. B006EXDC01
      B006BJ7 Place Hand Here
      B006DHE Remove in this Direction

      Detach the claw and guide as shown in the illustration.

    2. B006G25C01
      *A except Sport Package, w/ Illumination
      B006BJ7 Place Hands Here
      B006DHE Remove in this Direction

      except Sport Package, w/ Illumination:


      1. Disconnect the connector.

    3. Place both hands at the position shown in the illustration and pull towards the rear of the vehicle to detach the clip and guide and remove the instrument cluster finish panel assembly.

    4. B006AXF

      Disconnect the connector.

  11. REMOVE COMBINATION METER ASSEMBLY


    1. except Sport Package:


      1. B006G7TC01
        *A w/ Illumination

        Detach the clamp.

      2. w/ Illumination:

        Detach the clamp.

      3. Remove the 4 screws.

      4. B006G0WC01
        B006DHEC51 Remove in this Direction

        Pull in the direction of the arrow in the illustration and detach the pin and remove the combination meter assembly.

    2. B006D21

      for Sport Package:


      1. Detach the clamp.

      2. Remove the 4 screws.

      3. B0069ZRC01
        B006DHE Remove in this Direction

        Pull in the direction of the arrow in the illustration and detach the pin and remove the combination meter assembly.

    3. B006BZF

      Detach the wire harness clamp and disconnect the 2 connectors.