BLACK OUT TAPE(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

Tip:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
When removing the black out tape, heat the vehicle body surface and black out tape using a heat light.

Standard


Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)
Black Out Tape	20 to 30°C (68 to 86°F)

Note:

Do not heat the vehicle body or black out tape excessively.

PROCEDURE

PRECAUTION

Note:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).
REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

Click here
REMOVE FRONT DOOR TRIM MOULDING LH

Click here
REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

Click here
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Click here
REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH

Click here
REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

Click here
REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Click here
REMOVE FRONT DOOR GLASS RUN LH

Click here
REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH

Click here
REMOVE FRONT DOOR WEATHERSTRIP LH
1. Remove the upper part of the front door weatherstrip so that the black out tape can be removed.
REMOVE NO. 1 BLACK OUT TAPE LH
1. Heat the vehicle body surface and black out tape using a heat light.
2. Pull back an edge of the black out tape and pull it parallel to the vehicle body to remove it.
REMOVE NO. 2 BLACK OUT TAPE LH
1. Heat the vehicle body surface and black out tape using a heat light.
2. Pull back an edge of the black out tape and pull it parallel to the vehicle body to remove it.