AIRBAG CUT-OFF SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the airbag cut off switch cylinder sub-assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Pre-collision system	Click here

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

for Type A:

Click here

for Type B:

Click here

for Type C:

Click here

Note

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Click here
REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

Click here
REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Click here
REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Click here
REMOVE INSTRUMENT SIDE PANEL RH

Click here
REMOVE AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY
1. Detach the 2 claws and remove the airbag cut off switch cylinder sub-assembly.