SFI SYSTEM DTC CHECK / CLEAR

Tip:
  • DTCs which are stored in the ECM can be displayed on the GTS. The GTS can display the current and pending DTCs.

  • Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.

  1. CHECK DTC

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Trouble Codes.

    5. Check the DTC(s) and then write them down.

    6. Check the details of the DTC(s).

      Click here

      Powertrain > Engine > Trouble Codes

  2. CLEAR DTC

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Trouble Codes.

    5. Clear the DTCs.

      Powertrain > Engine > Clear DTCs

    6. Turn the ignition switch off and wait for a few minutes.