OUTER REAR VIEW MIRROR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH


    1. w/o Power Mirror Control System:


      1. A01SJV5C01
        B0069FO Install in this Direction

        Attach the claw and temporarily install the outer rear view mirror assembly LH.

      2. A01SHXRE01

        Install the outer rear view mirror assembly LH with the 3 bolts in the order indicated in the illustration.

        Torque:
        10.5 N*m  { 107 kgf*cm, 8 ft.*lbf }

        Note


        • When reusing the outer rear view mirror, be sure to temporarily install the screws by hand so that the threads of the mirror are threaded correctly.

        • As the threads of the mirror may become stripped, causing the mirror to fall off, do not tighten the screws with more than the specified torque.

        • When retightening the screws, do not retighten a screw more than 2 times. However, if the screw is being installed in the same location it was removed from, it is acceptable to retighten it 3 times.

    2. w/ Power Mirror Control System:


      1. A01SG1VC01
        B0069FO Install in this Direction

        Attach the claw and temporarily install the outer rear view mirror assembly LH.

      2. A01SI32C01
        B0068HS Bolt
        B006964 Connector

        Install the outer rear view mirror assembly LH with the 3 bolts in the order indicated in the illustration.

        Torque:
        10.5 N*m  { 107 kgf*cm, 8 ft.*lbf }

        Note


        • When reusing the outer rear view mirror, be sure to temporarily install the screws by hand so that the threads of the mirror are threaded correctly.

        • As the threads of the mirror may become stripped, causing the mirror to fall off, do not tighten the screws with more than the specified torque.

        • When retightening the screws, do not retighten a screw more than 2 times. However, if the screw is being installed in the same location it was removed from, it is acceptable to retighten it 3 times.

      3. Connect the connector.

  2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (w/ Power Mirror Control System)

    Click here

  3. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (w/ Power Mirror Control System)

    Click here

  4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (w/ Power Mirror Control System, for Driver Side)

    Click here

  5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (w/ Power Mirror Control System, for Front Passenger Side)

    Click here

  6. INSTALL FRONT ARMREST ASSEMBLY LH (w/ Power Mirror Control System)

    Click here

  7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  8. INSPECT POWER MIRROR CONTROL SYSTEM (w/ Power Mirror Control System)

    Click here