REAR COIL SPRING REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE REAR WHEEL

    Click here

  2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

    Click here

  3. REMOVE REAR SUSPENSION ARM COVER LH (w/ Cover)

    Click here

  4. REMOVE REAR STABILIZER LINK ASSEMBLY LH

    Click here

  5. LOOSEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

    C266840

    1. Loosen the 2 bolts of the rear No. 2 suspension arm assembly LH.

      Note:

      • Do not remove the bolts and nuts, only loosen them.

      • Since a stopper nut is used, loosen the bolt.

  6. REMOVE REAR COIL SPRING LH

    1. C129671

      Support the rear No. 2 suspension arm assembly LH with a jack.

      Note:

      Place a wooden or rubber block between the jack and arm.

    2. C129668

      Remove the bolt located on the rear axle carrier of the rear No. 2 suspension arm assembly LH.

    3. Lower the jack gradually to remove the rear coil spring LH together with the rear upper coil spring insulator LH.

  7. REMOVE REAR UPPER COIL SPRING INSULATOR LH

    1. Remove the rear upper coil spring insulator LH from the rear coil spring LH.

  8. REMOVE REAR LOWER COIL SPRING INSULATOR LH

    1. Remove the rear lower coil spring insulator LH from the rear No. 2 suspension arm assembly LH.