REAR AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing.

   Click here

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

   Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. REMOVE REAR SEAT ASSEMBLY (for Manual Seat)

   Tech Tips

   Perform the linked removal procedures until the No. 1 seat leg assembly step.

   Click here

4. REMOVE REAR SEAT ASSEMBLY (for Power Seat)

   Tech Tips

   Perform the linked removal procedures until the No. 1 seat leg assembly step.

   Click here

5. REMOVE SPARE TIRE (w/ Spare Tire)

   Click here

6. REMOVE REAR FLOOR FINISH PLATE

   Click here

7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

   Click here

8. REMOVE UPPER DECK TRIM SIDE BOARD LH

   Click here

9. REMOVE ROPE HOOK ASSEMBLY

   Click here

10. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

11. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

12. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

13. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH

    
    

    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

       CAUTION:

       Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Disconnect the airbag connector.

       Note

       When disconnecting any airbag connector, take care not to damage the airbag wire harness.

       
       

       1. Push down the housing lock and slide the CPA. (At this time, the connector cannot be disconnected yet.)

       2. Push the housing lock again and disconnect the airbag connector.

          Note

          Do not push down the upper part of the CPA shown in the illustration when disconnecting the airbag connector.

          

          *1	Housing Lock	*2	CPA
          *a	CPA Upper Part	-	-

    4. 

       Remove the nut.

       Note

       Loosen the nut while holding the side airbag sensor assembly LH because the side airbag sensor assembly LH guide is easily damaged.

    5. Detach the guide and remove the side airbag sensor assembly LH.