POWER SLIDE DOOR TOUCH SENSOR INSTALLATION


  1. INSTALL POWER SLIDE DOOR TOUCH SENSOR

    B007SIE

    1. Engage the 2 clips and install the power slide door touch sensor.

    2. Tighten the 3 bolts.

    3. Using "TORX" socket wrench T25, tighten the 6 screws.

    4. Connect the connector.

  2. INSTALL SLIDE DOOR SERVICE HOLE COVER LH

    B007P1K

    1. Apply butyl tape to the door panel, then install a new slide door service hole cover as shown in the illustration.

      Tech Tips


      • When installing the service hole cover, pull the links and connectors out through the service hole.

      • There should be no wrinkles or folds after attaching the service hole cover.

      • After attaching the service hole cover, check the quality of the seal.

    2. Connect the cable to the slide door lock remote control.

    3. Engage the clamp.

  3. INSTALL REAR NO. 2 DOOR WIRE


    1. B007SVI

      Engage the 4 clips and install the rear No. 2 door wire.

      Note

      Engage the clips by directly pushing them in by hand, not by tapping on the case surface.

    2. Tighten the 4 bolts.

      Note

      Do not tighten the bolts with any wire harness or cable wedged under the case as it may cause the case to deform or malfunction.

    3. B007UJ9

      Make sure that the wire harness is not twisted, and tighten the bolts after the clamp is fully secured by turning it in the direction indicated by the arrow mark.

    4. Connect the connector.

  4. INSTALL DOOR CONTROL RELAY ASSEMBLY

    B007PEY

    1. Install the door control relay with the bolt.

    2. Connect the connectors.

  5. INSTALL SIDE STEP REAR SUPPORT LH

    B007S5A

    1. Install the side step rear support with the 3 bolts.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }

  6. INSTALL REAR DOOR SCUFF PLATE LH


    1. B007R3Z

      Connect the connector.

    2. Engage the claw and 12 clips and install the rear door scuff plate.

  7. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. B007S92

      Engage the claw and 19 clips, and install the rear door trim board.

    2. B007T23

      Using "TORX" socket wrench T25, tighten the 2 screws.

  8. INSTALL SLIDE DOOR WINDOW GARNISH LH


    1. B007VXE

      Engage the 4 clips and install the slide door window garnish.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }