THROTTLE BODY REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE ENGINE UNDER COVER NO. 1 (w/ Engine Under Cover No. 1)

  3. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator reservoir cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    Tech Tips

    Collect the engine coolant in a container and dispose of it according to local regulations.


    1. Loosen the radiator drain cock plug and drain the engine coolant.

      B007PB7E01
      Text in Illustration
      *1 Radiator Reservoir Cap Sub-assembly *2 Radiator Reservoir Assembly
      *3 Radiator Drain Cock Plug *4 Cylinder Block Water Drain Cock Plug
      *5 2-Way - -

    2. Remove the radiator reservoir cap sub-assembly.

    3. Loosen the cylinder block water drain cock plug and drain the engine coolant from the engine.

  4. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

    Tech Tips

    Use the same procedures described for the LH side. Click here

  5. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

    Tech Tips

    Use the same procedures described for the LH side. Click here

  6. REMOVE FRONT DOOR SCUFF PLATE RH

  7. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Roll up the carpet, and remove the 5 bolts and engine service hole sub cover.

  8. REMOVE INTAKE AIR CONNECTOR


    1. B007TRDE01

      Slide the clamp and disconnect the No. 2 ventilation hose and vacuum hose. (A)

    2. Loosen the 2 hose clamp bolts. (B)

    3. Remove the 2 bolts and intake air connector. (C)

  9. REMOVE THROTTLE BODY ASSEMBLY


    1. B007S8DE01

      Disconnect the throttle motor connector. (A)

    2. Slide the clamp and disconnect the water by-pass hose. (B)

    3. Slide the clamp and disconnect the No. 2 water by-pass hose. (C)

    4. for Type A:

      Remove the 2 bolts and 2 nuts, and then remove the throttle body assembly. (D)

    5. for Type B:

      Remove the 4 bolts and throttle body assembly. (D)

    6. B007QLB

      Remove the gasket from the intake manifold.