KNEE AIRBAG ASSEMBLY(for Front Passenger Side) REMOVAL

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

    Click here

  3. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  6. REMOVE LOWER INSTRUMENT COVER LH

    Click here

  7. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    1. B247697

      Remove the 3 bolts.

    2. Detach the 6 claws and remove the instrument panel airbag.

    3. Disconnect the connector.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.