GENERATOR REASSEMBLY

PROCEDURE

  1. INSTALL GENERATOR REGULATOR ASSEMBLY

    1. A320043C01

      *a

      Brush

      *b

      Brush Cap

      Push in the brushes and slid the brush cap to hold the brushes in place.

    2. A316704C01

      *a

      Brush Cap

      Install the generator regulator assembly with the 3 bolts.

      4.3 N*m

      44 kgf*cm

      38 in.*lbf

    3. Push in the brush cap.

      Tip:

      By pushing in the brush cap after installing the generator regulator assembly, the brushes pop out and contact the slip rings.

    4. Install the generator rear end cover with the bolt and nut.

      3.9 N*m

      40 kgf*cm

      35 in.*lbf