Refer to the description for DTC P3147-239 Click here.
|DTC Detection Condition
|Hybrid vehicle transaxle assembly
|Planetary gear locked
CAUTION / NOTICE / HINT
If DTC P3147-240 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
After DTC P3147-241 has been output, drive the vehicle at approximately 9 mph (15 km/h) or more for approximately 10 seconds or more while maintaining a stable vehicle speed.
(If generator (MG1) does not rotate in this condition, DTC P3147-240 will be stored.)
If DTC P3147-242 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
When the vehicle is stopped, turn the power switch on (READY) and gradually depress the accelerator pedal so that the engine starts.
Drive the vehicle at approximately 12 mph (20km/h) or more for approximately 10 seconds or more while maintaining the vehicle speed.
CHECK DTC OUTPUT (HYBRID CONTROL)
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
Turn the power switch off.
REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY Click here
GO TO DTC CHART (P0A1D) Click here