NITROGEN OXIDES SENSOR INSTALLATION

PROCEDURE


  1. INSTALL NITROGEN OXIDES SENSOR ASSEMBLY


    1. A01WB7MC01
      *a Torque Wrench Fulcrum Length

      Using SST, install the nitrogen oxides sensor assembly.

      SST
      09922-10010
      Torque:
      Specified tightening torque
      70 N*m  { 714 kgf*cm, 52 ft.*lbf }

      Note

      Replace with a new part if it is dropped or if it receives a strong impact.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 132 mm (5.20 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 46 N*m (469 kgf*cm, 34 ft.*lbf)

    2. Install the bolt and connect the 6 clamps.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

    3. Connect the connector.