EGR COOLER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Panoramic view monitor system

Click here


  • Replacement of EGR valve assembly

  • Gas leak from exhaust system is repaired

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  4. REMOVE BATTERY

    Click here

  5. REMOVE FUEL PUMP PROTECTOR

    Click here

  6. REMOVE EGR PIPE CONNECTOR

    Click here

  7. REMOVE NO. 2 EGR PIPE

    Click here

  8. DISCONNECT ENGINE WIRE

    Click here

  9. REMOVE EGR VALVE WITH COOLER ASSEMBLY

    Click here

  10. REMOVE EGR COOLER ASSEMBLY


    1. B0083V0

      Slide the clip and disconnect the No. 1 water by-pass hose from the EGR cooler assembly.

    2. B0086JP

      Remove the 2 nuts and EGR cooler assembly from the EGR valve assembly.

    3. B0089KQ

      Remove the EGR valve gasket from the EGR valve assembly.