PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:C1A41

DTC Code DTC Name
C1A41 Brake Request Value Mismatch between ENG / EHV and Driving Support ECU

DESCRIPTION

The brake booster with master cylinder (skid control ECU) receives brake control request signals from the power management control ECU and driving support ECU assembly.

When the request signals received from the power management control ECU and driving support ECU assembly are not consistent, the brake booster with master cylinder (skid control ECU) determines that a malfunction has occurred and sends a malfunction signal to the driving support ECU assembly.

If the driving support ECU assembly receives a malfunction signal, DTC C1A41 is stored.

DTC No. DTC Detection Condition Trouble Area
C1A41 While the power switch is on (IG), a brake request signal from the power management control ECU and driving support ECU assembly are inconsistent for 3 seconds.

  • Electronically controlled brake system

  • Hybrid control system

  • Brake booster with master cylinder (skid control ECU)

  • Power management control ECU

  • Driving support ECU assembly

PROCEDURE


  1. CHECK DTC OUTPUT (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)


    1. Check DTCs for the electronically controlled brake system Click here.

      OK
      Electronically controlled brake system DTC is not output.

    NG

    GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM Click here

    OK

  2. CHECK DTC OUTPUT (HYBRID CONTROL SYSTEM)


    1. Check DTCs for the hybrid control system Click here.

      OK
      Hybrid control system DTC is not output.

    NG

    GO TO HYBRID CONTROL SYSTEM Click here

    OK

  3. REPLACE BRAKE BOOSTER WITH MASTER CYLINDER (SKID CONTROL ECU)


    1. Replace the brake booster with master cylinder (skid control ECU) (See page (for LHD), Click here (for RHD)).


    NEXT

  4. CHECK DTC OUTPUT (PRE-CRASH SYSTEM)


    1. Using the GTS, enter the following menus: Body Electrical / Pre-Crash 2 / Trouble Codes.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs.

      OK
      DTC C1A41 is not output.

    OK

    END BRAKE BOOSTER WITH MASTER CYLINDER (SKID CONTROL ECU) WAS DEFECTIVE

    NG

  5. REPLACE POWER MANAGEMENT CONTROL ECU


    1. Replace the power management control ECU Click here.


    NEXT

  6. CHECK DTC OUTPUT (PRE-CRASH SYSTEM)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus:


      1. Body Electrical / Pre-Crash 2 / Trouble Codes.

    5. Clear the DTCs Click here.

    6. Recheck for DTCs.

      OK
      DTC C1A41 is not output.

    OK

    END (POWER MANAGEMENT CONTROL ECU WAS DEFECTIVE)

    NG

    REPLACE DRIVING SUPPORT ECU ASSEMBLY Click here