STEERING ANGLE SENSOR (w/ VSC) INSTALLATION


  1. INSTALL SPIRAL CABLE SUB-ASSEMBLY


    1. Check that the front wheels are facing straight ahead.

    2. Set the turn signal switch to the neutral position.

      Note

      Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.

    3. Install the spiral cable.

      Note

      When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.

    4. Connect the connectors to the spiral cable.

      Note

      When handling the airbag connector, do not damage the airbag wire harness.

  2. INSTALL UPPER STEERING COLUMN COVER

  3. INSTALL LOWER STEERING COLUMN COVER

    A01DWPRE01

    1. Install the cover lower with the 3 screws.

  4. ADJUST SPIRAL CABLE

    A01DWY0

    1. Slowly rotate the spiral cable counterclockwise by hand until it feels firm.

      Note

      Do not use the airbag wire harness to turn the spiral cable.

    2. A01DYNOE01

      Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

      Note

      Do not use the airbag wire harness to turn the spiral cable.

      Tech Tips

      The spiral cable will rotate approximately 2.5 turns to the left and right from the center.

  5. INSTALL STEERING WHEEL ASSEMBLY


    1. A01DY2KE02

      for 3 spoke:

      Apply the silicon grease to the steering wheel.

    2. Align the matchmarks on the steering wheel and main shaft.

    3. Install the steering set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

  6. INSTALL STEERING PAD


    1. A01E02I

      Support the steering pad with one hand.

    2. Connect the connector to the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    3. Connect the horn connector.

    4. Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.

    5. Using a T30 "TORX" socket wrench, tighten the 2 screws.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.