TIRE PRESSURE WARNING RECEIVER(for Double Cab) INSTALLATION

PROCEDURE


  1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER


    1. Connect the connector to the tire pressure warning ECU and receiver.

    2. Attach the 2 guides to temporarily install the tire pressure warning ECU and receiver.

    3. Install the bolt.

      Torque:
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

  2. INSTALL BACK PANEL TRIM


    1. B00270AC01
      *A for Type A
      *B for Type B

      Install the back panel trim with the 5 clips.

  3. INSTALL QUARTER INSIDE TRIM BOARD LH

    Click here

  4. INSTALL QUARTER INSIDE TRIM BOARD RH

    Click here

  5. INSTALL SEAT BELT ANCHOR COVER CAP

    Click here

  6. INSTALL UPPER BACK PANEL GARNISH

    Click here

  7. INSTALL LOWER QUARTER TRIM PANEL LH

    Click here

  8. INSTALL LOWER QUARTER TRIM PANEL RH

    Click here

  9. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  10. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

  11. INSTALL REAR SEAT ASSEMBLY


  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  13. REGISTRATION OF TRANSMITTER ID

    Click here

  14. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

  15. PERFORM INITIALIZATION

    Click here