REAR AIRBAG SENSOR(for Wagon) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR AIRBAG SENSOR LH

   
   

   1. 

      Check that the ignition switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      
      

      • w/ Navigation System for HDD:

        After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

   3. Install the rear airbag sensor with the nut.

      Torque:

      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note

      
      

      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

   4. Check that the rear airbag sensor is not loose.

   5. Connect the connector.

2. INSTALL REAR SIDE SEATBACK ASSEMBLY LH

   Click here

3. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY

   Click here

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

5. CHECK SRS WARNING LIGHT

   
   

   1. Check the SRS warning light Click here.