AUDIO AND VISUAL SYSTEM(for Radio and Display Type) DATA LIST / ACTIVE TEST
DATA LIST
Note:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Tip:Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Navigation System / Data List.
According to the display on the GTS, read the Data List.
Body Electrical > Navigation System > Data List
Tester Display
Measurement Item
Range
Normal Condition
Diagnostic Note
Battery Voltage
Battery voltage
Min.: 0 V, Max.: 24 V
11 to 14 V
-
Active Dimmer
Active dimmer function
ON or OFF
ON: Active dimmer function on
OFF: Active dimmer function off
-
Tail Light SW
Tail light switch
ON or OFF
ON: Light control switch in tail or head position
OFF: Light control switch off
-
Reverse Signal
Reverse signal
ON or OFF
ON: Shift lever in R
OFF: Shift lever in any position other than R
-
Parking Brake
Parking brake switch
ON or OFF
ON: Parking brake applied
OFF: Parking brake released
-
Ignition
Ignition switch
ON or OFF
ON: Ignition switch ON
OFF: Ignition switch off or ACC
"OFF" is displayed even though the ignition switch is turned to ACC
Vehicle Speed
Maximum wheel speed sensor reading
Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
Vehicle stopped: 0 km/h (0 mph)
When driving at constant speed: No large fluctuations
HDMI Line(Blu-ray Disc Player)
-
Disconnected or Connected
Disconnected
Not available