CLEARANCE WARNING BUZZER(for Front Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure as for the RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicles.

PROCEDURE


  1. INSTALL NO. 1 CLEARANCE WARNING BUZZER


    1. B006E4F

      for LHD:


      1. Connect the connector.

      2. Attach the clamp to install the No. 1 clearance warning buzzer.

    2. B006EGN

      for RHD:


      1. Connect the connector.

      2. Attach the clamp to install the No. 1 clearance warning buzzer.

  2. INSTALL NO. 1 HEATER TO REGISTER DUCT

    Click here

  3. INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY

    Click here

  4. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    for 8GR-FKS:

    Click here

    for V35A-FTS:

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  6. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. CHECK SRS WARNING LIGHT

    Click here