ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during E.F.I. engine coolant temperature sensor and engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • E.F.I. engine coolant temperature sensor

  • Engine coolant temperature sensor

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE RADIATOR COVER PLATE

    Click here

  3. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  4. REMOVE LOWER RADIATOR AIR DEFLECTOR

    Click here

  5. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. B006AKF

      Disconnect the engine coolant temperature sensor connector.

    2. B006ATD

      Remove the clip and engine coolant temperature sensor from the water inlet assembly.

      Note

      If the engine coolant temperature sensor has been struck or dropped, replace it.

    3. Remove the gasket from the engine coolant temperature sensor.

  6. REMOVE E.F.I. ENGINE COOLANT TEMPERATURE SENSOR


    1. for Front:


      1. B006EPU

        Disconnect the E.F.I. engine coolant temperature sensor connector.

      2. B006GBSN01

        Using SST, remove the E.F.I. engine coolant temperature sensor.

        SST
        09817-33191

        Note

        If the E.F.I. engine coolant temperature sensor has been struck or dropped, replace it.

      3. Remove the gasket from the E.F.I. engine coolant temperature sensor.

    2. for Rear:


      1. Remove the cowl top ventilator louver sub-assembly.

        Click here

      2. B006FUG

        Disconnect the E.F.I. engine coolant temperature sensor connector.

      3. B006EFFN01

        Using SST, remove the E.F.I. engine coolant temperature sensor.

        SST
        09817-33191

        Note

        If the E.F.I. engine coolant temperature sensor has been struck or dropped, replace it.

      4. Remove the gasket from the E.F.I. engine coolant temperature sensor.