DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:C1A10

DTC Code DTC Name
C1A10 Front Radar Sensor

DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle.

When the driving support ECU assembly receives information that there is a malfunction in the millimeter wave radar sensor assembly, DTC C1A10 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A10 Front Radar Sensor

w/o Full-speed range following function:


  • While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the driving support ECU assembly receives a malfunction signal from the millimeter wave radar sensor assembly for approximately 0.3 seconds or more.

w/ Full-speed range following function:


  • While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the driving support ECU assembly receives a malfunction signal from the millimeter wave radar sensor assembly for approximately 0.3 seconds or more.

 Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

Note


  • When replacing the millimeter wave radar sensor assembly, make sure to replace it with a new one. If a device which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle, and as a result, a DTC may be stored.

  • When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

    Click here

PROCEDURE


  1. REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. Replace the millimeter wave radar sensor assembly with a new one.

      Click here

    2. Perform millimeter wave radar sensor assembly adjustment.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    END