REAR PLANETARY GEAR REASSEMBLY


  1. INSTALL REAR PLANETARY RING GEAR FLANGE

    A01E2WJE01

    1. Install the ring gear flange.

    2. Using a screwdriver, install the snap ring.

  2. INSTALL REAR PLANETARY FLANGE THRUST NEEDLE ROLLER BEARING

    A01DVF9E01

    1. Coat the races and the bearing with petroleum jelly, and install them onto the planetary ring gear.

      Standard races and bearing diameter
      Item Inside Outside
      Race (A) 28.5 mm (1.122 in.) 44.2 mm (1.70 in.)
      Assembled bearing and race (B) 27.7 mm (1.091 in.) 44.2 mm (1.70 in.)

  3. INSTALL NO. 1 PLANETARY CARRIER THRUST WASHER

    A01DVTOE01

    1. Coat the thrust washer with petroleum jelly.

    2. Install the thrust washer onto both sides of the planetary gear.

      Tech Tips

      Make sure that the tabs of the washer fit into the cutout portions of the planetary gear.

  4. INSTALL NO. 2 PLANETARY CARRIER THRUST WASHER

    A01DYIAE01

    1. Coat the thrust washer with petroleum jelly.

    2. Install the thrust washer onto both sides of the planetary gear.

      Tech Tips

      Make sure that the tabs of the washer fit into the cutout portions of the planetary gear.

  5. INSTALL NO. 2 ONE-WAY CLUTCH

    A01DXY3E01

    1. Install the one-way clutch and 2 retainers into the planetary gear.

      Tech Tips

      Make sure that the open ends of the guides on the one-way clutch are facing upward.

    2. A01E2N7E01

      Using a screwdriver, install the snap ring.

    3. A01DWFWE01

      While turning the one-way clutch inner race counterclockwise, install the one-way clutch inner race to the planetary gear.

  6. INSPECT NO. 2 ONE-WAY CLUTCH

    A01DX8JE01

    1. Hold the planetary gear and turn the one-way clutch inner race. Check that the one-way clutch inner race can be turned freely counterclockwise and locks when turned clockwise.

  7. INSTALL REAR PLANETARY RING GEAR

    A01E0EDE01

  8. INSTALL PLANETARY OUTPUT SHAFT OIL SEAL RING

    A01E31JE01

    1. Coat the oil seal ring with ATF, and install it to the output shaft.

      Tech Tips

      After installing the oil seal ring, check that it rotates smoothly.

      Note

      Do not expand the ring excessively.

  9. INSTALL OUTPUT SHAFT

    A01E10VE01