RELAY ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT ST RELAY

   1. 

      Check the resistance.

      1. Measure the resistance according to the value(s) in the table below.

         Standard Resistance

         Tester Connection	Condition	Specified Condition
         3 - 5	Battery voltage not applied to terminals 1 and 2	10 kΩ or higher
         	Battery voltage applied to terminals 1 and 2	Below 1 Ω

         If the result is not as specified, replace the ST relay.

2. INSPECT ST CUT RELAY (w/o Smart Entry and Start System)

   1. 

      Check the resistance.

      1. Measure the resistance according to the value(s) in the table below.

         Standard Resistance

         Tester Connection	Condition	Specified Condition
         3 - 4	Battery voltage not applied between terminals 1 and 2	Below 1 Ω
         	Battery voltage applied between terminals 1 and 2	10 kΩ or higher
         3 - 5	Battery voltage not applied between terminals 1 and 2	10 kΩ or higher
         	Battery voltage applied between terminals 1 and 2	Below 1 Ω

         If the result is not as specified, replace the ST CUT relay.