TRANSMISSION CONTROL CABLE INSTALLATION

PROCEDURE

  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

    Note:

    Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in neutral.

    1. Put the transmission control cable assembly into the cabin and connect the transmission control cable assembly with the 2 bolts.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

    2. Connect the clamp of the transmission control cable assembly with the bolt.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

    3. Connect the transmission control cable assembly to the control cable support.

    4. Connect the transmission control cable assembly to the bracket with a new clip.

    5. Connect the transmission control cable assembly to the control shaft lever with the nut.

      12 N*m

      122 kgf*cm

      9 ft.*lbf

    6. Turn the nut of the transmission control cable 180° counterclockwise. While holding the nut in place, push in the stopper to lock the nut.

      Note:

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

      C203379C01

      *1

      Stopper

      *2

      Nut

      *a

      Push in

      -

      -
      Tip:

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

    7. Install the outer part of the transmission control cable assembly to the shift lever retainer. Check that the stopper returns to the pulled out position.

      C203380C01

      *1

      Stopper

      *2

      Nut

      *3

      Shift Lever Retainer

      -

      -
    8. C203381C10

      *1

      Slider

      *2

      Lock Piece

      Slide the slider in the direction shown in the illustration and pull out the lock piece.

    9. C204586

      Connect the end of the transmission control cable assembly to the shift lever.

      Note:

      • Make sure that the lock piece is pulled up.

      • Push on the end of the transmission control cable assembly all the way to the base of the pin.

    10. C279319C01

      *1

      Cable Rod

      Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.

    11. Push the lock piece into the adjuster case and lock it.

      Note:

      Make sure that the lock piece is completely locked by the slider.

  2. INSTALL FRONT FLOOR COVER

    Click hereClick hereClick hereClick here

  3. INSTALL AIR CLEANER CASE

    Click here

  4. INSTALL AIR CLEANER CAP AND HOSE

    Click hereClick here

  5. INSTALL BATTERY BRACKET REINFORCEMENT

    Click here

  6. INSTALL FRONT BATTERY BRACKET

    Click here

  7. INSTALL BATTERY TRAY

  8. INSTALL BATTERY

  9. INSTALL BATTERY CLAMP SUB-ASSEMBLY

    Click here

  10. INSTALL NO. 2 CYLINDER HEAD COVER

    Click hereClick here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  12. INSPECT SHIFT LEVER POSITION

    Click here

  13. ADJUST SHIFT LEVER POSITION

    Click here

  14. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

    Click hereClick here