NAVIGATION ANTENNA REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    1. Remove the instrument panel safety pad (Click here).

  4. REMOVE INSTRUMENT PANEL STAY LH (for LHD)

    Click here

  5. REMOVE NAVIGATION ANTENNA ASSEMBLY (for LHD)

    1. B222027

      Remove the 2 screws and heater to register duct assembly.

    2. B222507

      Detach the 3 clamps.

    3. Remove the 2 screws and navigation antenna.

  6. REMOVE NAVIGATION ANTENNA CORD SUB-ASSEMBLY (for LHD)

    1. B222523

      Detach the 2 clamps and remove the navigation antenna cord.

  7. REMOVE INSTRUMENT PANEL STAY RH (for RHD)

    Click here

  8. REMOVE NAVIGATION ANTENNA ASSEMBLY (for RHD)

    1. B229223

      Remove the 2 screws and heater to register duct assembly.

    2. B222508

      Detach the 3 clamps.

    3. Remove the 2 screws and navigation antenna.

  9. REMOVE NAVIGATION ANTENNA CORD SUB-ASSEMBLY (for RHD)

    1. B455843

      Detach the 2 clamps and remove the navigation antenna cord.