FRONT UPPER SUSPENSION ARM INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart (Click here).

PROCEDURE

  1. TEMPORARILY INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY LH

    1. G020153

      Temporarily install the suspension upper arm and 2 washers with the bolt and nut.

      Tip:

      After stabilizing the suspension, tighten the nut.

    2. C214444

      Connect the bracket with the bolt.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

    3. C261540

      Install a new nut and clip.

      110 N*m

      1122 kgf*cm

      81 ft.*lbf

  2. INSTALL SKID CONTROL SENSOR WIRE

    Click here

  3. INSTALL FRONT WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf

  4. STABILIZE SUSPENSION

    Click hereClick here

  5. TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH

    1. Tighten the nut.

      115 N*m

      1173 kgf*cm

      85 ft.*lbf

  6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    1. Inspect and adjust the front wheel alignment (Click hereClick here).