BLOW BY HEATER ON-VEHICLE INSPECTION

PROCEDURE

  1. INSPECT BLOW BY HEATER (VENTILATION NO. 1 CONNECTOR) (w/ HEATER)

    1. A325884

      Disconnect the blow by heater(ventilation No. 1 connector) connector.

    2. Disengage the 2 clamps.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      B44-1 - B44-2

      25°C (77°F)

      10.5 to 20.0 Ω

      If the result is not as specified, replace the blow by heater(ventilation No. 1 connector).