REAR DOOR BELT MOULDING INSTALLATION

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

2. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

   
   

   1. 

      Engage the 8 claws to install the rear door belt moulding assembly.

3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

4. INSTALL REAR DOOR REAR GUIDE SEAL

   Click here

5. INSTALL REAR DOOR WINDOW GUIDE SUB-ASSEMBLY

   Click here

6. INSTALL REAR DOOR GLASS RUN

   Click here

7. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

8. INSTALL REAR DOOR TRIM BRACKET

   Click here

9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

10. INSTALL REAR DOOR ARMREST COVER

    Click here

11. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

12. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

13. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

14. INSTALL DECK FLOOR BOX RH

    Click here

15. INSTALL REAR DECK FLOOR BOX

    Click here

16. INSTALL NO. 1 DECK BOARD

    Click here

17. INSTALL NO. 2 DECK BOARD

    Click here

18. INSTALL DECK BOARD ASSEMBLY

    Click here

19. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

20. INSPECT POWER WINDOW OPERATION

    Click here