ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of engine coolant temperature sensor Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here w/ Canister Pump Module

Click here w/o Canister Pump Module

CAUTION:

Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

B007Z4V

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. B005LNI

      Disconnect the engine coolant temperature sensor connector.

    2. B005M24

      Remove the clip and engine coolant temperature sensor from the water outlet.

      Note

      If the engine coolant temperature sensor has been struck or dropped, replace it.