REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH


    1. B0025B9C02
      B0069FO Install in this Direction

      Attach the claw to install a new rear door belt moulding assembly LH as shown in the illustration.

    2. Remove the protective tape.

  2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  4. INSTALL REAR DOOR GLASS RUN LH

    Click here

  5. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  6. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  8. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  9. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  10. INSTALL REAR ARMREST ASSEMBLY LH

    Click here

  11. INSTALL REAR DOOR FRAME GARNISH LH

    Click here

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here