CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

  1. INSTALL CRANKSHAFT POSITION SENSOR

    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

      Note:

      • When reusing the camshaft position sensor, inspect the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.

    2. A273389C01

      *1

      Protrusion

      Install the crankshaft position sensor with the bolt.

      8.8 N*m

      90 kgf*cm

      78 in.*lbf

    3. Install the crankshaft position sensor wire harness with the clip.

      Note:

      Make sure the crankshaft position sensor wire harness is installed in the position shown in the illustration.

    4. Install the harness clamp bracket with the bolt.

      8.8 N*m

      90 kgf*cm

      78 in.*lbf

    5. Connect the crankshaft position sensor connector.

  2. INSTALL GENERATOR ASSEMBLY

    Click here