POWER WINDOW REGULATOR MOTOR(for Rear Door) INSPECTION

PROCEDURE

1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

   1. 

      *1	Motor Gear
      *a	Component without harness connected (Power Window Regulator Motor Assembly LH)
      	Clockwise
      	Counterclockwise

      Apply battery voltage to connector terminals 1 (U) and 2 (D).

      Note:

      Do not apply battery voltage to any terminals except terminals 1 (U) and 2 (D).

   2. Check that the motor gear rotates smoothly as follows.

      OK

      Measurement Condition	Specified Condition
      Battery positive (+) → 2 (D) Battery negative (-) → 1 (U)	Motor gear rotates clockwise
      Battery positive (+) → 1 (U) Battery negative (-) → 2 (D)	Motor gear rotates counterclockwise

      If the result is not as specified, replace the power window regulator motor assembly LH.

2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

   1. 

      *1	Motor Gear
      *a	Component without harness connected (Power Window Regulator Motor Assembly RH)
      	Clockwise
      	Counterclockwise

      Apply battery voltage to connector terminals 1 (U) and 2 (D).

      Note:

      Do not apply battery voltage to any terminals except terminals 1 (U) and 2 (D).

   2. Check that the motor gear rotates smoothly as follows.

      OK

      Measurement Condition	Specified Condition
      Battery positive (+) → 2 (D) Battery negative (-) → 1 (U)	Motor gear rotates counterclockwise
      Battery positive (+) → 1 (U) Battery negative (-) → 2 (D)	Motor gear rotates clockwise

      If the result is not as specified, replace the power window regulator motor assembly RH.