BRAKE MASTER CYLINDER(for LHD) REASSEMBLY

PROCEDURE

  1. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER

  2. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

  3. INSTALL MASTER CYLINDER RESERVOIR GROMMET

    1. C303937C01
      V100144

      Lithium Soap Base Glycol Grease

      Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new master cylinder reservoir grommets.

    2. Install the 2 master cylinder reservoir grommets to the brake master cylinder body.

  4. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

    1. Secure the brake master cylinder body in a vise.

      Note:

      Place aluminum plates on the vise to prevent damage to the brake master cylinder body.

    2. Install the brake master cylinder reservoir assembly to the brake master cylinder body.

      Note:

      Do not drop the brake master cylinder reservoir assembly.

    3. Using a T20 "TORX" socket wrench, install the "TORX" screw to secure the brake master cylinder reservoir assembly to the brake master cylinder body.

      4.0 N*m

      41 kgf*cm

      35 in.*lbf

    4. Remove the brake master cylinder sub-assembly from the vise.