GENERATOR REMOVAL

PROCEDURE

1. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

   Click hereClick hereClick hereClick hereClick here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick hereClick hereClick hereClick hereClick here

3. REMOVE NO. 1 ENGINE COVER

   Click hereClick here

4. REMOVE FAN AND GENERATOR V BELT

   Click here

5. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

   Click hereClick hereClick here

6. REMOVE WIRE HARNESS CLAMP BRACKET (for DPF)

   1. 

      Disconnect the air fuel ratio sensor connector and detach the wire harness clamp.

   2. Remove the bolt and wire harness clamp bracket.

7. REMOVE GENERATOR ASSEMBLY

   1. 

      *A	for CCo
      *B	for DPF

      Detach the wire harness clamp and disconnect the generator connector.

   2. Remove the terminal cap.

   3. Remove the nut and disconnect the terminal B.

   4. Remove the bolt and disconnect the wire harness.

   5. 

      Remove the 3 bolts and generator assembly.