FRONT AXLE HUB BOLT REPLACEMENT

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE FRONT WHEEL

  2. DISCONNECT FRONT FLEXIBLE HOSE

    1. C153576

      Remove the bolt and disconnect the flexible hose.

  3. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    1. C130484

      Remove the 2 bolts and disconnect the front disc brake caliper assembly from the steering knuckle.

      Note:

      Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.

  4. REMOVE FRONT DISC

    Click here

  5. REMOVE FRONT AXLE HUB BOLT LH

    C159676C01

    *1

    Nut

    *a

    Hold

    *b

    Turn

    1. Temporarily install 2 nuts and 2 washers to the front axle hub bolt as shown in the illustration.

    2. Using SST and a brass bar or an equivalent tool to hold the front axle, remove the front axle hub bolt.

      09611-12010

  6. INSTALL FRONT AXLE HUB BOLT LH

    1. C159674C01

      *1

      Washer

      *2

      Nut

      *a

      Hold

      *b

      Turn

      Install a washer and nut to a new front axle hub bolt as shown in the illustration.

    2. Using a brass bar or an equivalent tool to hold the front axle, install the hub bolt by tightening the nut.

    3. Remove the nut and plate washer.

  7. INSTALL FRONT DISC

    Click here

  8. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    1. Connect the front disc brake caliper assembly to the steering knuckle with the 2 bolts.

      106.8 N*m

      1089 kgf*cm

      79 ft.*lbf

  9. CONNECT FRONT FLEXIBLE HOSE

    1. Connect the front flexible hose to the steering knuckle with the bolt.

      18.5 N*m

      189 kgf*cm

      14 ft.*lbf

  10. INSTALL FRONT WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf