OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

    1. Remove the adhesive from the threads of the oil pressure sender gauge assembly and the bolt hole of the No. 1 oil cooler bracket.

    2. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note:

      Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.

    3. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      15 N*m

      153 kgf*cm

      11 ft.*lbf

      Note:

      Do not start the engine for at least 1 hour after installation.

    4. Connect the oil pressure sender gauge connector.

  2. ADD ENGINE OIL

    Click here

  3. INSPECT FOR OIL LEAK

    Click here

  4. INSPECT ENGINE OIL LEVEL

    Click here

  5. INSTALL NO. 1 ENGINE COVER

    Click hereClick hereClick here