STARTER(w/ Stop And Start System) REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

      Click hereClick here

    • When the starter assembly is replaced, "starter relay assembly" must be also replaced.

  2. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  4. REMOVE NO. 1 ENGINE UNDER COVER

  5. REMOVE BATTERY

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

  8. REMOVE NO. 3 AIR HOSE

  9. REMOVE NO. 2 AIR TUBE

  10. REMOVE NO. 1 AIR TUBE

    Click here

  11. REMOVE STARTER ASSEMBLY

    1. A204768

      Open the terminal cap.

    2. Remove the nut and disconnect terminal 30.

    3. Disconnect the starter assembly connector.

    4. A204769

      Remove the 2 bolts and starter assembly.