ANTI-LOCK BRAKE SYSTEM (w/ Rear Differential Lock) DTC CHECK / CLEAR

CHECK DTC (When not using intelligent tester:)

Read the DTC from the ABS warning light on the combination meter.

Tech Tips

If no code appears, check the TC circuit or ABS warning light circuit.

Trouble Area	See procedure
TC and CG terminal circuit	Click here
ABS warning light circuit	Click here

If more than 1 DTC is detected at the same time, the DTCs will be displayed in numerical order.
As an example, the blinking patterns for a normal system code and DTCs 11 and 21 are shown in the illustration.
DTCs are explained in the Diagnostic Trouble Code Chart.

After completing the check, disconnect terminals 13 (TC) and 4 (CG) of the DLC3, and turn off the display.

CHECK DTC (When using intelligent tester:)
1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch ON.
3. Read the DTCs by following the prompts on the tester screen.
  
  Tech Tips
  
  Refer to the intelligent tester operator's manual for further details.
CLEAR DTC (When not using intelligent tester:)
1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
  
  SST
  
  09843-18040
2. Turn the ignition switch ON.
3. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
4. Check that the ABS warning light displays the normal system code.
5. Remove SST from the terminals of the DLC3.
  
  Tech Tips
  
  DTCs cannot be cleared by removing the battery cable or ECU-IG and GAUGE fuse.
CLEAR DTC (When using intelligent tester:)
1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch ON.
3. Operate the intelligent tester to erase the codes.
  
  Tech Tips
  
  Refer to the intelligent tester operator's manual for further details.
CHECK ABS WARNING LIGHT
1. Turn the ignition switch ON.
2. Check that the ABS warning light illuminates and then turns off in approximately 3 seconds.