REAR BRAKE (for 4WD and Pre-Runner) DISASSEMBLY

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.


  1. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH

    A01E0VY

    1. Using needle-nose pliers, remove the adjust lever tension spring and lever.

  2. REMOVE BRAKE SHOES

    A01E2CJ

    1. Using pliers, remove the shoe hold down springs, pins, front brake shoe and rear brake shoe.

    2. A01DZU5

      Push the front or rear side of the wheel brake cylinder with the brake shoe. Then remove the side of the brake shoe opposite to the side of the cylinder being pushed. Finally remove the remaining side of the brake shoe.

      Note

      Be careful not to damage the cylinder dust boot.

    3. A01DVO6

      Move one of the shoes downward and remove the shoe tension spring.

    4. A01E268

      Remove the brake shoe front and rear side.

    5. Remove the strut set and return spring from the shoe.

    6. Remove the support clip from the strut set and return spring.

    7. A01E1FT

      Using needle-nose pliers, disconnect the No. 3 parking brake cable from the parking brake shoe lever.

  3. REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY

    A01DY5A

    1. Using a screwdriver, remove the C-washer and lever.

  4. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY LH

    A01E2KK

    1. Using a union nut wrench, disconnect the brake line.

    2. Remove the 2 bolts and cylinder.

  5. REMOVE REAR WHEEL BRAKE CYLINDER CUP


    1. Remove the 2 cylinder dust boots from the cylinder.

    2. Remove the 2 pistons and compression spring.

    3. Remove the 2 wheel cylinder cups from each piston.

  6. REMOVE REAR BRAKE DRUM BLEEDER PLUG


    1. Remove the bleeder plug cap and bleeder plug from the cylinder.