CAMSHAFT POSITION SENSOR REMOVAL

PROCEDURE

  1. REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)

    1. A352555

      Disconnect the camshaft position sensor connector.

    2. Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

      Note:

      If the camshaft position sensor has been struck or dropped, replace it.

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click hereClick hereClick hereClick here

  3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click hereClick here

  4. REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)

    1. A354281C01

      *1

      Fuel Tube Sub-assembly

      *a

      Sensor Wire Connector

      Disconnect the fuel tube sub-assembly from the hose clamp.

    2. Remove the 2 bolts and separate the fuel vapor feed pipe from the cylinder head cover sub-assembly.

    3. Disconnect the sensor wire connector.

    4. A352552C02

      *a

      10 mm Union Nut Wrench

      Using SST and a 10 mm union nut wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

      09961-00950

      Note:

      If the camshaft position sensor has been struck or dropped, replace it.

    5. A352553

      Disconnect the camshaft position sensor connector to remove the camshaft position sensor from the sensor wire.