FRONT SPEED SENSOR (for 2WD) REMOVAL

Tech Tips


  • The procedures listed below are for the LH side.

  • Other than areas where instructions are provided, use the same procedures for the LH side and RH side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT WHEEL

  3. REMOVE FRONT SPEED SENSOR LH


    1. Disconnect the connector.

      A01DY0GE01

    2. Detach the 2 clamps and the connector.

    3. A01E1AEE01

      Detach the clamp and remove the bolt and harness clamp.

    4. A01DYZPE01

      Remove the bolt and harness clamp.

    5. A01DZG8E01

      Remove the 3 bolts, 2 harness clamps and speed sensor.

      Note

      Keep the sensor tip and sensor installation hole free from foreign matter.