FRONT SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedures listed below are for the LH side.

PROCEDURE

  1. REMOVE FRONT WHEEL

  2. REMOVE FRONT FENDER LINER LH

    1. Partially remove the front fender liner.

      Tip:

      It is not necessary to fully remove the fender liner. Partially remove it so that the speed sensor connector can be disconnected in a later step.

  3. REMOVE FRONT SPEED SENSOR LH

    1. C274696

      Disconnect the front speed sensor connector.

    2. C274697E01

      Remove the sensor clip labeled A, bolt labeled B and sensor clamp labeled C.

    3. C274698E01

      Remove the sensor clip labeled D, bolt labeled E and sensor clamp labeled F.

    4. C274699

      Remove the bolt and front speed sensor from the knuckle.

      Note:

      Keep the sensor tip and sensor installation hole free from foreign matter.