GLOW PLUG (w/o DPF) INSTALLATION


  1. INSTALL GLOW PLUG

    Note


    • Measure the resistance of the glow plug when reinstalling it.

      If the result is not as specified, replace it with a new one.

    • Replace the glow plug with a new one when it has been dropped or subjected to a physical impact.

    • Remove any carbon deposits from the glow plug hole when reinstalling it.


    1. B007P2ZE01

      Wrap tape around a 4 mm drill, 118.5 mm (4.665 in.) from its tip.

    2. Insert the drill 118.5 mm (4.665 in.) into the glow plug hole and remove the carbon deposits by manually turning the drill.

    3. Insert the 4 mm drill into the glow plug hole and remove any carbon deposits from the tip end portion of the glow plug hole by manually turning the drill.

    4. Install the 4 glow plugs.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

      Note

      Do not use any tools, such as air tools, which are liable to cause any impact to the glow plugs, when installing them.

  2. INSTALL NO. 2 INTAKE MANIFOLD INSULATOR

  3. INSTALL NO. 1 GLOW PLUG CONNECTOR


    1. Temporarily install the No. 1 glow plug connector with the 4 nuts.

    2. Tighten the 4 nuts to the specified torque.

      Torque:
      2.2 N*m  { 22 kgf*cm, 19 in.*lbf }

    3. Install the 4 screw grommets.

    4. Connect the wire harness to the No. 1 glow plug connector and install the nut.

      Torque:
      2.6 N*m  { 27 kgf*cm, 23 in.*lbf }

    5. Install the screw grommet.

  4. INSTALL MANIFOLD STAY


    1. Install the manifold stay with the 2 bolts.

      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

  5. INSTALL COMMON RAIL

    Click here