VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1417

DTC Code	DTC Name
C1417	High Power Supply Voltage Malfunction

DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the master cylinder solenoid) stores this DTC and the fail-safe function prohibits ABS/VSC/TRC operation.

This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.

This DTC is cleared when the IG1 terminal voltage returns to normal.


DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C1417	High Power Supply Voltage Malfunction	The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more.	Charging system Power source circuit Internal power supply circuit of the skid control ECU

WIRING DIAGRAM

Refer to DTC C1241 (Click here).

CAUTION / NOTICE / HINT

Note:

When replacing the master cylinder solenoid, perform calibration (Click here).

PROCEDURE

CHECK TERMINAL VOLTAGE (IG1)

Disconnect the A7 skid control ECU connector.

*a	Front view of wire harness connector (to Skid Control ECU)

Measure the voltage according to the value(s) in the table below.

Standard Voltage


Tester Connection	Switch Condition	Specified Condition
A7-46 (IG1) - Body ground	Engine switch on (IG)	11 to 14 V

Result


Result
OK
NG

NG

GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION)

Click here

OK

RECONFIRM DTC

Clear the DTCs.
Click here

Chassis > ABS/VSC/TRC > Clear DTCs

Check if the same DTCs are output.

Click here

Result


Result	Proceed to
DTC is not output	A
DTC is output	B

Chassis > ABS/VSC/TRC > Trouble Codes

A

USE SIMULATION METHOD TO CHECK

Click here

B

REPLACE MASTER CYLINDER SOLENOID

Click here